You may need to click on the next picture and enlarge it for a better view. I was pretty sure that I had found the problem when I spotted the light corrosion. Note the spring clip at the front of the switch panel. Then I lifted the rear of the panel up to release all of the spring clips. Now that the pull handle was removed and out of the way, I used a plastic pry bar to lift the switch panel from the door. It should be noted that the bolts have shoulders on them and should not be mixed with other bolts in the door panel. There are two 10 mm headed screws that hold the pull handle in place. Once it was out far enough, I had to slightly depress the tab as you cane see below.Īfter the tab was released the insert came the rest of the way out with little resitance. The interior pull handle has to be removed before the switch can be. I needed to check signals at the power door lock switch on the driver’s door but some dis assembly was needed. The passenger side switch works but only the lock on the passenger side door. Never load the vehicle beyond the manufacturer's maximum gross vehicle weight rating (GVWR).This 2008 Chevrolet Silverado came in with the complaint that the driver’s power door lock switch would not work the door locks. Hellwig springs are made to increase the "level-load" carrying capacity of your vehicle. Hellwig products come with a Million Mile WarrantyĬlick here to view Installation Instructions Notes
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2023
Categories |